1999 Chevrolet Silverado 1500 "not start" Questions

not start Just a week ago the truck started spitting and sputtering when i started it and sometimes when I was driving it... Now it won't start. I changed the fuel filter , the engine turns over , but

...would not restart it would roll over but not start. 20 min later it started and ran fine. I tried to start it today and it will not start. It may be the cam position sensor or the crank position ...

...not start New battery, new starter, new alternator, newer fuel pump one year old. Truck starts one day runs great next day will not turn over. The next time it does not start have someone crank it ...

Cranks over but will not start the fist time Engine will not start first time cranked over, stop cranking and start cranking a second and some times a third before it will start change your fuel ...

...not start. Your truck will not start if the indicator says that it is in gear as this is a safty feature on most cars and trucks. i would say that your shift indicator has a mecanical problem and ...

...not start. New plugs , crank sensor , distributor , cap, rotor . ignition control moduel. Has fire to plugs but will not start. Whats the fuel pressure like? Will it run on starting fluid? You may ...

...not start after sitting for an hour or two. It cranks over but will not fire. Can start it by jumping, but after sitting again it will not start. Have replaced the battery & cables, starter, ...

...start and drive and would go dead after a few miles and would not start until it cooled down, turned out to be the ignition module that eventually went bad and would not start at all. Vick.. Right

...not start i had the fuel pump replaced about a month ago but here lately it has been taken alot of cranking to start now won't start any ideas When I had a problem with my silverado not starting, I ...

...not start, no codes show up on code reader, fuel pressure at test port when key is turned on goes to 50 psi but will not start need to check fuel pressure before trying to start and see if it's ...