1999 Chevrolet Silverado 1500 "99 chevy 4x4 transfer case" Questions

...99 chevy silverado iv replaced the rear, front rear, trans, tranfer case, tailshaft and drive shafts no idea what is going on I need a bit more information I take it this a 4x4 cause when you talk ...

99 Chevy Silverado 4x4 not working No light on 4x4 Selector Panel I have a 99 Chevy Silverado and the 4x4 switch panel has no light on even in 2wd. I replaced the switch panel and no luck. I know the ...

...99 chevy silverado has a issue with the 4x4 inside the transfer case the gear just slips in and out whenever it wants causing loud thumping and griding noises..........is it all junk now can it still ...

99 chevy silverado 4x4 stopped working. 2wd light stayed on and wouldn't shift to 4 hi. when I start truck, a clicking noise in the switch dash area could be heard for a few seconds. installed a new ...

...chevy silverado 4x4 when i turn the dial to 4wheel low the light blinks for a while then it goes to 4 wheel high it doesn't matter if Im stopped or moveing 1-2 mph 4 wheel low engages only when u ...

...on my 99 Chevy Silverado.When I put it under load in 4-wheel drive there is a clunking sound like a chain slipping on a sprocket. Is this hard to replace? never knew 4x4 had a chain inside the box

...99 chevy silverado 1500 LS 5.3 4x4 ext cab short bed It does not seem that sufficient diagnosis was done. No, you cant give a specific diagnosis like that without tearing unit down. It's likely that ...

...99 chevy blazer. Trying to get 4x4 working since it hasn't worked in years. I put new vacuum switch in transfercase and vacuum accuator under the battery. Also a new dash push button switch. Problem ...

...99 chevy tahoe 4X4 5.7. My service 4wd dash light comes on when I put my truck in auto 4. I drive about 150 - 200 feet and the light comes on and will not switch back into 2wd. I have to shut the ...

99 Chevy k1500 push button 4x4 not working please help I have change the front actuator motor I tested it for power I'm getting power I am not getting power to the transfer case selector motor but if ...