1999 Pontiac Sunfire "clutch chatter" Questions

...clutch will slip and chatter.  Turning it is always recommended, but not necessarily always needed. By turning, I mean the shop would cut and remove the surface to the lowest groove point and ...

...clutch and then the chatter goes away with the transmission fully engaged that the flywheel is the culprit. Even if it was new it should have at least been checked for warpage Let me know if you have ...

...sound when the clutch is pushed,you need a trow-out bearing usually slipping espacially in higher gears, also chatter or noise, when you do the clutch get the flywheel resurfaced or you may get ...

chatters on take off Clutch, pressure plate, throw-out bearing needs to be replaced. BE SURE they "turn" the fly wheel to prevent the chatter with the new clutch kit.

...WHAT TYPE VEHICLE OR YEAR BUT I WILL TRY TO HELP,IF IT ALSO SLIPS OR CHATTERS IN HIGH GEAR SUSPECT CLUTCHES, HIGH GEAR AND REVERSE OPERATE OFF THE SAME CLUTCH ...

...clutch chatter and only there with pedal pushed. It happens when the car is worm only and the phenomenon comes and goes. When it goes it shifts like butter with not slipping, noise etc. the Flywheel, ...

...clutch chatter and your performance will be poor mileage will drop. And the clutch chatter can cause the flywheel to be damaged and need to be surfaced, it could burn up the slave cylinder, so it is ...

I have noise at the clutch and when i press the clutch pedal the noise go off Did you check you clutch fluid level? It may be low. Also chattering is usally an early sign that the pressure ...

...gears. Stickshift also chatters in gear while driving The clicking could be due to worn shifter linkage bushings. As for the chatter you may need to replace the clutch and resurface the

...clutch chatter it has had two complete clutch kits with brand new flywheel why the clutch chatter ? Good pilot bearing? Wear on the input shaft bearing? Have the run-out checked on the input shaft? ...