nissan ca18det wont start i have a 1990 english nissan 200sx with a ca18det engine, the car wont start but there is a spark and its getting fuel, i think it could be crankshaft sensor but i dont know ...
wiring ca18det to ignition i just did a 240sx ca18det conversion into my 1986 R31 SKYLINE it was previously ca18s (twin spark carbuerator model). what wires do i run from ecu to ignition? i know i ...
differential front and rear i have a 1994 suzuki sierra (samurai) with a ca18det silvia motor in it, want to know what diffs would be the easiest swap or if it would be cheaper to strengthen the ...
My ca18det is splattering when I rev it. Can any help I want to renew the charters allaxei.pos to do
What would cause spluttering when reving car ca18det Bad spark plugs, replace spark plugs. Clean Mass Air Flow. Ensure air filter is clean or replace.. Clean throttle body.
My ca18det won't start unless I pour a little bit of fuel down the bout. Once it starts it's really rough idling. When I rev it she splatters then when I reach ova 4-5 grand revs it's fine. I really ...
I have a 1990 Nissan 180sx ca18det and my aftermarket tacho isn't reading the right rpms I have the tacho signal wire connected to the 7 pin on the ecu I have connected up the light, power and neg
How do I line up my cas sensor on my ca18det properly? And if it's out by much would that cause my car to splutter when driving? Crank angle sensor =CAS DTC code 11 . or Cam angle sensor = CAS s work ...
hallo there.I have n overheating problem with my 200SX S13.I had it before and i replaced the ca18det moter and whent from n single core radiator to n double core radiator from n golf 3 replaced water
45 questions posted
Usually answered in minutes!
141 Questions
125 Questions
122 Questions
90 Questions
25 Questions