...V6 -4.3Liter Firing Order is 1-6-5-4-3-2 Distributor rotor turns Clockwise Number 1 spark plug tower on distributor cap, faces the front of the engine. ->Drivers side, spark plug order in engine, ...
...v6 4.3 there is no routine timing adjustment for the 4.3L engine, timing is controlled by the computer. If you are talking about timing after replacing the distributor, there is just the basic rotor ...
...replace the distributor 1. Disconnect the set timing connector or ground the Tan/Black bypass wire. 2. The check engine light should come on and code 42 should set. 3. If the engine stops stalling, ...
Question about Chevrolet 1500
...V6 engine are attached to right connecting points on distributor cap. The firing order for a Chevy s10 depends on which engine you have. 1.9L engine the firing order is: 1-3-4-2 . Distributor rotates ...
Question about Chevrolet 1500
...distributor ,ignition wires , egr, intake gasket replaced , throttle body, fuel pump, vehicle still stalls what couild it be 1990 chevy camaro rs v6 - engine surges and stalls at idle. Loses power at ...
...V6 Auto. Trans. It wont start. The engine turns over and it's enough air and fuel so I've determined that it's and electrical problem. I've replaced the battery and the ignition coil. The distributor ...
Question about Cars & Trucks
...s10 v6 4.3 still won't fire over. ALSO GETTING GAS. But the engine straight won't start Which sensors? Did you check timing. Pull the distributor and check the gear at the bottom of it. They wear
v6 it wont start i check fuel pump,fuses and replaced distributor cap and rotor. havent check spark plugs or wires. it wont start... Check for broken timing belt. Put a screew into spark plug head put
...should start even if the water pump has been removed. An 86 model would have a V6 or a V8 engine and both use a distributor, have you checked for spark at the plugs and fuel in the carb or injector
...distributor used to be driven from. All I had to do was remove the plate, replace the gasket fitted between the plate and the opening, and oil could no longer seep through there. As I remember, I had ...
1,180 questions posted
Usually answered in minutes!
878 Questions
754 Questions
575 Questions
561 Questions
414 Questions