1992 Oldsmobile Ninety Eight Regency "crankshaft balance" Questions

...regency 98 elite crankshaft sensor? Remove the crankshaft pulley,the harmonic balance,with a puller made for this,then you can replace the sensor,and align it,if it is not aligned,it will break

1992 olds cutlass 3.1L shuts off low injector voltage which crankshaft sensor is bad it has 2 the engine has a 24X and a 3X sensor which should be changed 24X behind harmonic balancer or otherone Your

...shaft pulley on 91 oldsmobile You will need to remove the bolt(s) and then use a gear puller. The crankshaft pulley normally a harmonic balancer also and will be keyed with a drift pin. You should ...

...and easy to use-available at any auto parts store.  The hardest part is getting the crankshaft pulley bolt loose.  An impact tool is best, but not absolutely

The serpentine belt pulley on the crankshaft dampener has separated from the dampener and is moving forward, throwing the belt off. It is about 1/2 inch forward, and a black rubberish gasket is ...

...LOCATE CRANK POSITION SENSOR WHERE IS THE CRANK SENSER LOCATED ON A 95 MONTI CARLO 3.4 ENGINE 7X Crankshaft Position (CKP) Sensor Lower rear of engine 4 25 -- 24X Crankshaft Position (CKP) Sensor ...

need to replace the crankshaft position sensor REMOVAL & INSTALLATION Disconnect the negative battery cable. Remove the serpentine drive belt from the crankshaft pulley. Raise and safely support ...

Crankshaft Position Sensor and Camshaft Position Sensor I need some step-by-step instructions on how to change the crankshaft position sensor and the camshaft position sensor on my 1994 Buick Regal ...

...UPDATED BY TSB #91-T-05 DATE: 9/90 The harmonic balancer on these engines is now press fit onto the crankshaft and requires the use of Tool J-38197 for removal. The torque specification to be used ...

...VIBRATION DAMPER CRANKSHAFT THROWS AND FLYWHEEL ALL BALANCE THE CRANKSHAFT.IF CRANKSHAFT OUT OF BALANCE AND VIBRATION GOOD AND THE CRANKSHAFT THRUST BEARING NOT WORN.CRANKSHAFT COULD BE