how to replace a timing gear Remove the bolt in the center of the crank shaft damper pulley Use a special puller to remove the pulley Remove the timing cover & use a puller if doing the crank gear
...crank pully, if I idol up quickly it goes away for a short time, but I know can move the serpentine belt and all the pullies with the engine off not quit a 1/4 turn, is there a clutch system with the ...
I am trying to change the crank sensor because, times when I turn the key the engine just turn but won't start. Keep trying after 20 minuts ro so and cranks right up. trying to remove the harmonic
...time the car died out of nowhere. So, I replaced the Fuel Filter and Fuel Pump and car still won't start. What should I try next? unplug the cam sensor behind the water pump pulley; see if it starts; ...
Question about Buick Riviera
...The car was warm and running normally. When I backed up slowly, it stalled. It started after 6 cranks. It stalled again at the next stop sign. Started again after 7 cranks, it ran rough, ...
where is crank sensor located on 1993 Buick LaSabre located? Under hood, passenger side, lower engine area, rear of crankshaft pulley, mounted in timing cover
...filter. You might want to replace the spark plugs and wires at the same time. I would install a new fuel filter and see how it runs. have the crank and cam sensors checked also; could even be the ...
Question about Buick Riviera
my 1993 Riviera will not crank to start,a few times this haws happened,tho by depressing break,and re-seating shifter.it always has..untill lastnight..and now even with a jump it will not crank..could
no fuel in a 95 buick riviera car wont start, cranks fine, got spark, no power to injectors. they wont fire, they work and i have fuel pressure. any ideas? sounds like bad gas, i would put some fuel ...
Car cranks over but back fires and will not start check timing belt timing is most likely off.
63 questions posted
Usually answered in minutes!
621 Questions
245 Questions
219 Questions
125 Questions
112 Questions