2001 Oldsmobile Intrigue "spark plug" Questions

...Spark Plug: Service and Repair REMOVAL PROCEDURE TOOLS REQUIRED J 43094 Spark Plug Boot Puller 1. Turn OFF the ignition switch. 2. Remove the ignition coil assembly. 3. Use the J 43094 in order to ...

...spark plug boot connecting the coil to the spark plug. Remove the ignition coil assembly. Use the J 43094 to remove the spark plug boots from the spark plugs. NOTE: Allow the engine to cool before ...

...Spark Plug Socket to remove and install Spark Plugs. Replace (remove) one Wire Connections at a time from one Spark Plug. Replace One Spark Plug at a time. Use Anti-Seize Grease applied moderately to ...

how do i change the spark plugs On the 4 cylinder engines the spark plugs are located on the top of the engine, but not visible.There should be a cover that tells you that it is DOHC 16valve or ...

Spark Plug Wires, Spark Plug Wire Puller, 6 Spark Plugs (AC Delco; gapped at .05), Socket Wrench, 6 inch extender, 3 inch extender 5/8 Spark Plug Socket, 10mm Socket, Anti-seizing Compound, Compressed

...spark plug wires from the spark box to each of the 6 plugs...I recommend you use AC platinum tip plugs, verify the gap...should be 45 mm...spark plug gap tools are inexpensive and available at all ...

...spark plug removal socket. Usually 5/8 with a rubber fitting in the top of it to grab onto the spark plug. Locate your distribution center where the six wires feed out to the spark plugs. If you ...

...spark plug setting for a 2000 oldsmobile intrigue 6 liter what is the best spark plug gap setting for this car? there should be a decal under the hood somewhere that shows what the plug gap is. it`s ...

...spark plug wires and the spark plugs HI, Spark plugs or wires will cause engine shaking, but not SMOKING. I would identify the source of the SMOKE first. If it is a fuel leak the smoke may turn to ...

...spark plug socket, 3/8" drive, 3" & 6" extensions. Disconnect the negative battery cable from battery.Use the 10mm to remove the bolts (6) holding the coil over plug pack. Use a 3" or less ...