...change coolant in my 1999 olds cutlass and i cannot find the drain plug It is located at bottom of radiator, you will need 1/2 inch square drive or a 3/16 inch hex drive to open drain valve. Usually ...
...Oldsmobile Cutlass V6 is running way hot. I have replaced 2 thermostats,the water pump,radiator,coolant,fuses,and fan relays. But yet the car is still running at just below the red on the gauge ...
...So I did replace that but still just as before the guage reads hot and upon a 7-8 mile drive all coolant is spraying out the overflow tube on the coolant tank. I do bleed the system correctly
...warmed to operationg temp. I had to manually run fans by turning on AC to level 1, stopped my coolant from exiting the overflow, which might be the case for you/might not? this was accidental ...
Question about Oldsmobile Cutlass
...the cylinder head bolts. If the problem persists, check the radiator for clogged, or perform the coolant system test and replace the cylinder head
...change it, drain out some of your coolant (enough to get it below the height of the connection) undo the 2 bolts that hold that metal connection on. Seperate the 2, and you'll see the thermostat. ...
Coolant leak, unknown origin My 1998 Oldsmobile Cutlass 3.1L is leaking coolant but I can't seem to find the exact location. It seemed to be coming from the upper coolant hose that connects to the ...
may have air in your lines. Open your radiator, then start your car and let it run for a while, add coolant when it drops low. There are bleeder screws on your car for your coolant. When the car is at
...change the thermostat: Make sure the car engine is cool to cold. Don't try to remove it after driving. It can be dangerous. There is a danger of getting burnt by boiling hot water if you ignore this ...
401 questions posted
Usually answered in minutes!
319 Questions
8 Questions
6 Questions
1 Questions
4 Questions