...air out of the engine it will continue to run hot and you may have already damaged the engine! It doesn't take much at all to damage the engine by running them hot, so be very careful! Make sure that ...
ENGINE BLOCK.NOW YOU SEE CAN AND REMOVE THE THERMOSTAT HOUSING REPLACE THE THERMOSTAT.BESURE TO HAVE EXTRA COOLANT ON HAND.BLEED COOLANT SYSTEM WHEN DONE.TO BLEED COOLANT SYSTEM REMOVE RADIATOR CAP ON
Question about Oldsmobile Alero
...Replace water pump. Check coolant level also. Open the bleeder valve usually located on thermostat housing to remove air from system. close valve when coolant is present while filling. close radiator ...
engine is off and cold and add coolant/water mixture till fluid streams from bleeder screw(will need to be removed) then tighten screw and install radiator cap.Let it idle and see if it over heats and
...engine when warm, open bleeder screw slightly. air should come out, wait for steady stream of coolant. Then lock down bleeder screw. with the engine running, open the bleeder until you see a steady ...
...engine still running and what bleeder till there is no more air and just coolant, close bleeder replace radiator cap and problem should be solved if not replace thermostat and follow the above ...
...engine new coolant did you release air from cooling system when replacing coolant!! if air is trapped in system it will not heat up proper. turn fan on high heat locate bleeder for cooling system, ...
...air trapped in the heater core preventing warm coolant to circulate into the heater core. try this 1 open radiator cap fill coolant and put heater in hi heat 2 start engine and wait until you see the ...
Question about Oldsmobile Alero
...replace and bled system very little heat? If you look on the passenger front of the engine you should see a pipe coming up from the water pump housing. There should be a bleeder screw on the top. use ...
Question about Oldsmobile Alero
...Replace the coolant air bleeder, front and center top of the engine. Remove the 10mm bolts holding the air intake down, prop it a a few inches, take the four bolts out and the two bolts holding the ...
1,892 questions posted
Usually answered in minutes!
1,272 Questions
1,097 Questions
1,065 Questions
830 Questions
662 Questions