remove the starter and check the condition of the ring gear and pinion teeth. Any burrs on either makes it hard for the pinion to engage the fly wheel a split second before the armature starts to spin
...pinion shaft bearing The ring gear is bolted to what is called a ring gear carrier, the carrier is bolted inside the rear end housing with two bolts on each side, it is shimmed on each side to adjust ...
Question about Dodge Cars & Trucks
...socket with an air gun remove nut then push out pinion gear from differential. to assemble check clearances of side bearings and pinion/ring gear contact clearances, and proper torque for pinion
...Pinion, ring, spider gears, pumpkin, bearings? Rebuilding it FULLY and PROPERLY is a big story, one too big to relate here, and it takes quite a lot of special tooling (differential spreader, dial ...
...ring and pinion gears as well as the bearings becasue when the pinion bearing goes bad it will spin on the pinion gear itself causing it to wear thus just replacing the bearing will not work because ...
Question about Oldsmobile Cutlass Ciera
...ring and pinion, and for that you will need a dial indiactor, so you can get the right back lash. but my advice to you is, if you have never done this before it best to have a professional do it for ...
...Ring and Pinion may need replacing. Also check preload on the pinion bearings. Nut on end yoke may be loose. Sometimes the axle gears will make a clunking noise if worn out.Check out drive shaft ...
...of the pinion it takes to get one full turn of the ring gear. For example, if we divide a ring gear with 41 teeth by a pinion gear with 10 teeth we find that the gear ratio is 4.10:1 (41/10 =
...on one of the rearend cover bolts indicating the ratio.if not remove cover count all the teeth on the ring gear and pinion,divide the ring gear # by the # of pinion teeth and that will be your
Question about Oldsmobile Cutlass Ciera
...ring gear and carrier assembly; remove the drive shaft; remove Pinion Flange Nut; Remove Pinion Flange; Remove Pinion. Press off old Pinion baring be careful not to lost Pinion shim located beneath ...
676 questions posted
Usually answered in minutes!
575 Questions
540 Questions
492 Questions
412 Questions
332 Questions