1995 Oldsmobile Cutlass Ciera "hard start" Questions

1990 CUTLASS CIERA 2.5L HAVING A HARD TIME STARTING. CUTLASS CIERA 2.5L HAVING A HARD TIME STARTING. HAVE REPLACED FUEL INJECTOR, O2 SENSOR. STILL RUNS ROUGH IN IDLE, GAS MILEAGE SO SO, STILL HARD ...

...hard to start For about a year now, I have been working on a problem with my 1994 Oldsmobile Cutlass Ceira 3.1L, Once every 2 weeks the car is very hard to start, so much so that I had burnt out 3 ...

hard to start, after its been running a while. I have replaced everything, crank sensor, icm, coils? Can anybody help? Have you taken an actual voltage measurement at the battery? If the voltage is in

hard to start. Now will not start. It tries but no luck make sure you have power to the pump, have some one turn it on and you check it with a test light. it should come on for two second. if not then

...start hard be hard to start but it will start go easy on the gas after it starts and let it run a bit at idle Let me know how it goes and if this information is helpful please give me a fixya! Rating ...

HARD IT JUST DIES.WILL START BACK UP,AND THEN THE SAME THING ,STEP DOWN,BOGS THEN DIES,NOW WONT START sometimes the tank decomposes from the inside flaking off and clogging filters, pumps, etc. always

have a vacuum leak somewhere these are sometimes hard to find. Start at the throttle body should be a couple lines there look for holes,cracks in the lines at throttle body and continue down the lines

...Hard to start cold and won,t stay running untill started a couple of times,and misses while driving under light throttle pressure at 70kph. try a new set of spark plugs individually, one at a time, ...

engine started to turn over real hard when starting on my 96 cutlass ciera this car was starting just fine bad battery or out of time? Check the battery first. Use a voltmeter-if it is not at least 12

...start. remove the starter and check the condition of the ring gear and pinion teeth. Any burrs on either makes it hard for the pinion to engage the fly wheel a split second before the armature starts ...