1992 Oldsmobile Cutlass Ciera "balancer puller" Questions

balancer puller for this car what size screws do i need im not sure wich size bolts you need but if you go to a parts store that has a balancer in stock they can match up the bolts you need. I had the

...and gear and was wondering if the bolt for the harmonic balancer is right or left handed thread. and what type of puller do i need to remove the balancer Go to AUTO ZONE or call. they will tell ...

...http://www.autozone.com/autozone/accessories/Tools-Garage-and-Equipment/Harmonic-Balancer-Installer/_/N-25qp Auto Zone usually has these tools to loan! Hope I helped, ...

...to do is remove the belts off of the accs. then remove the bolts out of the balancer and use a puller to remove it. it will stay in time. the timing gear has a key on the crank to hold it in

...balancer, there are threaded holes that will take a 6 X 1.0 mm bolt. You need these bolts about 3 1/2 inches long. Screw them in through the puller hand tight only. If you screw one of them in to ...

...balancer)(crankshaft pulley).You will have to remove the bolt in the pulley first,to do this.You will have to remove the starter or there might be a small shield where the tranny and engine ...

...balancer puller. Not the two or three armed pulley puller, but a harmonic balancer pulley puller-the pullers with jaws that hook around the outside of pulley can ruin a harmonic balancer. Use the ...

how to take the harmonic balancer off hyundai santa fe 01 2. How to take the crank puly off use a harmonic balancer puller, Harmonic Balancer Puller KD Tools 2286 Harmonic Balancer Puller Tonzof com

balancer" puller, It has slots that bolt to the inner part of the balancer and you screw in the big center bolt. As you tighten the bolt it "pulls" the balancer. Here is a picture; for that you need a

balancer off. A puller is often required. Parts stores sell balancer removal pullers for not very much. Usually there is just enough room to fit the puller onto the balancer and pull it off. Sometimes