2001 Dodge Stratus "time alignment" Questions

What is the correct timing position for crank and the dual overhead cams? Check this Chrysler document about Timing Marks for aligning crankshaft & camshaft timing marks on dual cams. Hope helped ...

...and wearing out,could it be that the rear wheels need alignment? Yes, it could be alignment, it could also be wheel bearing's, have it check out, at that time they will check wheel bearing's

just replaced timing belt on 99 stratus, now it will not start, cranks but will not start...anything??? recheck to be certain it is aligned properly,. fortunately for you this is a non-interference ...

...alignment check is related. Hi there it sounds like it is time for a tune up.Normally when driving at a steady speed of 55 you will feel the car shake or slow down.That usually indicates bad plug ...

timing chain guide broke..jumped time and broke middle gear. How do you set timing without being able to turn crank and cams at the same time to align. Do you remove cams or just turn to align???? ...

need for 2002 dodge stratus 2.7 timing chain diagram online Remove the timing belt. Crankshaft and camshaft timing marks-2.4L engine Timing belt tensioner-2.4L engine Camshaft sprocket alignment-2.4L ...

I have a 2.4 single overhead cam. I have aligned the counter balance shaft and the crank shaft cogs with the engine marks. I removed the 8mm bolt toward the rear of the engine and was able to insert a

...to Haynes manual diagram but it still won't start. It tries to start but is obviously still out of time. check your distributor position,double check all marks again,make sure when u line up the ...

just change timing belt on 98 dodge stratus 2.4l getting code of camshaft sensor malfunction could it be that timing is off Who replaced the timing belt? The timing could be off cause timing marks ...

I need the timing mark alignments for a 2005 dodge stratus It doesn't have timing marks as the timing cannot be adjusted. The timing on the Stratus is computer controlled via the cam and the crank ...