...Small Blocks since 1967) (2.21.2011 00:42 PST) Replace the oil sending unit (pressure switch) Before doing so, check to make sure wire connected to it is tight. A loose wire can produce same
...From the drivers point of view it is in the 11:00 o'clock position. The harness wraps around the back of the bellhousing and plugs in on the passenger side of the block near the oil sending
...O, clock slightly behind the distubtor shaft torward the fire wall you kind of have to crawl over the engine to see it and by the way the oil pressure sending unit is on the oppisite side same ...
...Oil Pressure/Sending Unit Sensor or it's Electrical Connection located adjacent to the Oil Filter. Locate the Sensor Unplug and check both sides of the electrical connections. Check for corrosion or ...
sending unit 10. Remove the upper half of the timing belt cover 11. Remove the valve cover 12. Disconnect the wiring harness connector that is just to the right of the throttle body 13. Disconnect the
sending unit 10. Remove the upper half of the timing belt cover 11. Remove the valve cover 12. Disconnect the wiring harness connector that is just to the right of the throttle body 13. Disconnect the
sending unit 10. Remove the upper half of the timing belt cover 11. Remove the valve cover 12. Disconnect the wiring harness connector that is just to the right of the throttle body 13. Disconnect the
sending unit 10. Remove the upper half of the timing belt cover 11. Remove the valve cover 12. Disconnect the wiring harness connector that is just to the right of the throttle body 13. Disconnect the
3,122 questions posted
Usually answered in minutes!
1,496 Questions
1,337 Questions
1,299 Questions
1,150 Questions
1,016 Questions