1999 Dodge Durango "old truck runs start position" Questions

truck was too old for them to be familiar they offered to dig around for MORE MONEY. Your problem reminds me that they said something inside the column wears out and they may not be able to fix. I was

runs great, untill a few mins later it will start to hesist. It will almost loose power completely, i can put the accelerator down all the way and the car will not move. i have to feather the throttle

...start-up running but it stops after a while or it my run good for hours. But it doesn;t seem to be at high speed when it;s running. If you can hit on the blower motor housing and the motor starts, ...

...start rev up and and then quit. If i push on the gas i can keep it alive and then it will quite as soon as I let off the gas. If i keep it reved and manage to get it to drive and can go with out ...

...old pcm back in and the light still flashes and the same ldp code anyone have this prob or know what could cause it thanks What code is it showing for the leak detection pump ? That pump along with ...

...start the car, but I had to use the old ignition switch's passcode sensor with my new ignition switch. I have the old passscode sensor wired in. But I want to use the new passcode sensor that came ...

...Start" position. Release the key leaving it in the "Run" position. If the "Security" light is flashing allow the key to remain in the "Run" position for at least 10 minutes. After 10 minutes have ...

...old fashioned battery boost from another car or truck. leave the other car running while boosting your. run booster cable from the booster car to your truck make sure to run them the same way on each ...

...start and can drive it for about 20 min does it again Fuel pump 2 yrs old, new fuel filter and plugs wires 1 yr old indicates dirty injectors bad wiring to injectors problem crank/ cam position ...

...old. The timing is off. When you replaced the distributor, did you mark the position when you took it off? You will need the firing order of your vehicle and bump the starter to the correct position ...