2001 Chevrolet Impala "install throttle position sensor 3" Questions

...throttle body. Install the MAF sensor mounting screws. Tighten the mounting screws to 27 in lb (3 Nm). Connect the mass air flow (MAF) sensor electrical connector. Install the fuel injector cover. ...

...install to begin with.............my current shop is frustrated.......help!! depending on mileage, but possible tune-up could fix it. if already done then check ignition coil pack and ignition wires ...

...throttle body. Unsnap the two clips for the air filter. Remove the filter cover and inlet tube. Remove the air filter (Does it look OK? Well, at least shake it out a little.) Remove the two 8mm bolts ...

Throttle position (TP) sensor electrical connector TP sensor To install: Install the screws and the TP sensor. Tighten screws to 7 inch lbs. (3 Nm) Connect the throttle position (TP) sensor electrical

...install the throttle sensor, aligning the matchmarks. Install and hand-tighten the retainer screw. Connect the throttle sensor electrical harness. Connect the negative battery cable. Hope this help ...

...throttle valve opening based on the TPS output voltage. Removal & Installation Disconnect the negative battery cable. Disconnect the sensor connector. Remove the sensor retaining screws. Remove ...

...Install the TP sensor (2) on to the throttle body (1). Tighten Tighten the TP sensor screws to 2.3 N·m (20 lb in). Connect the IAC electrical connector (1) to the IAC sensor (4). Connect the MAP ...

Install: The throttle shaft end of throttle body slides into a socket in TPS. The TPS must be installed so that it can be rotated a few degrees. If sensor will not rotate, install sensor with throttle

...Throttle House off, clean it completely with Carbuerator Cleaner. 8. Install the new TPS. and installation is reverse of above. Good Luck, let me know if it helped and is there is anything else I can ...

...Install the TP sensor (2) on to the throttle body (1). Tighten the TP sensor screws to 2.3 Nm (20 inch lbs.). Connect the IAC electrical connector (1) to the IAC sensor (4). Connect the MAP sensor ...