...pulley for bearing failure. Replace belt. The balancer will make a loud knocking sound if it is bad. Check any other pulleys also. A tensioner will move some at idle and will smooth out when engine ...
...belt tension How do you relieve the tension on the Buick serpentine belt? One pulley is a tensioner. Put a wrench on the nut in the center of the pulley and relieve the tension from the
...pulley nut to rotate the tensioner ... Fig. Fig. 9: ... then remove the belt from the pulleys Fig. Fig. 10: Serpentine drive belt routing and removal - 3.8L (VIN L) engine shown, VIN C similar Fig. ...
pulley for sure loosen up the tensioner and take the old stuff out it shouldnt be hard to do What i've seen in those front-wheel drive, transverse 3800 v6 engines, or any of the like, is that there is
...pulley nut to rotate the tensioner ... ... then remove the belt from the pulleys find the belt tensioner on the car should take a 1/2 drive ratchet or a 15mm wrench pull on the tensioner to release ...
...tensioner has gone bad internally. The tension of the belt pulls the pulley out of line with the rest of the pulleys and the belt just walks off the edge of the tensioner. Replace the tensioner arm ...
Question about Buick LeSabre
...pulley on the tensioner, however, has theb earings shot. I do not need a whole new assembly, just the pulley. I got my pulley part and am trying to remove the bad pulley. I just brooke my socket ...
...noise comming from my tension pulley how do i fix it? You probably need to replace the tensioner pulley... some you can just replace the pulley and others you have to replace the tensioner ...
...tensioner pulley,down to power steering pump pulley,then you use either a 3/8 ratchet or a 15mm socket to rotate tensioner down to the right. this method will allow you to install the belt over the ...
2,358 questions posted
Usually answered in minutes!
1,731 Questions
1,084 Questions
904 Questions
897 Questions
779 Questions