1988 Mitsubishi Mighty Max "replace water pump bypass fitting" Questions

...Route it around the Crank Shaft pully, to the Water pump pully and the Alternator pully adjust the belt tension at the Alternator set screw.& bolt  Works Great...  HAPPY MIGHTY MAX

Water Pump Housing the Plastic elbow from Manifold to WP Housing... Amazon com APD 58176IQ Coolant Bypass Fitting Tube Upgraded Metal Aluminum... autozone and such sell o rings, replace both elbows, I

...replace the water pump . Looking for direction Drain the cooling system. Remove the accessory drive belt. Remove the lower radiator hose. Disconnect the heater hose from the pump, if fitted. Always ...

along the frame on the drivers side near the rear axle. I would replace the water pump and gasket first so you can inspect the other components, then try to start it again before taking further action

...bypass the heater core on a 97 buick le sabre Ok to eliminate having heat in your vehicle and/or replacing a damaged heater core unhook both the 5/8" id hoses going to your heater core then remove ...

...water pump. Clean mating surfaces thoroughly before installation. This would be a good time to replace radiator hoses. At least, inspect them carefully for aging or other damage. If the heater hose ...

water pump going out how do i replace it Removal of the Fan Shroud and Drive Belts 1 Drain the cooling system. Place a waste oil collection pan underneath the petcock valve on the lower corner of the ...

...out of the water pump and the other end connects to the engine intake . There is a fitting there that the hose attaches to look close as most of the time it will be under the air conditioner

...water pump to intake manifold above and behind water pu connector that goes into manifold has broken off at manifold. can this be replaced and what is it called? It's made of plastic. does it just ...

water-pump bypass hose began leaking profusely with no warning. Now I get about 1 mile per gallon of water into the radiator. I took off the ''bypass hose'' and there was no obvious defect in the hose