Question about Chevrolet Cobalt
...error codes po741 comes up. While driving rpm jumps up to 3000\4000 alo has caused emission light to come on with error code po401. P0741 Torque Converter Clutch System Performance Or Stuck
engine light on wont go over 3000rpm or under 2000rpm trouble-the revs are stuck at 2000 on idle and will only go up to 3000 and the check engine light is on. Diagnostics showed errors on throttle ...
...3000 rpm, this valve plate opens to improve high-speed exceleration. the valve plates are opened and closed by the IMRC deactivation by the powertrain control module (pcm) if your car or truck is not ...
...3000 rpm. If i turn it off and leave for a while the coil light goes off and its drives perfect again but management light stays on.. I checked it with dtc scanner comes up error code p0638... any ...
Question about Cars & Trucks
...error codes, but cant rev it over 3000 rpm in park, in drive barely 2/2,5, no error messages exept i have a warn out brake pad. Have changed the high presure pump from a part car, no differense, no ...
3000 miles. 2004 dodge ram 3500 5.9 diesel dually 2wd. When the abs light appears,the brakes reset to regular brakes,with out the anti lock,If for sure the brake liners are good,and the rotors,then it
Question about Chevrolet Cobalt
3000-3500 rpm), service engine soon light comes on. After 5-10 min at high rpm service light goes out and car resumes normal idle. This should be a drive by wire vehicle meaning it has a cable for the
Question about Chevrolet Cobalt
...and torque converter(TC) lock up(TCU runs the SHOW) There is s TV cable here too, that causes upshifts late or early. super hard top find this, Asian boxes. but here goes. ?1st: 2.80 ?2nd:
Question about Ford Cars & Trucks
I have a ford expedition 2002 my oil light is on and my temperature gauge is below 0. I replaced the intake cylinder? 5 sensor a couple of months ago. helper here guesses you meant INJECTOR 5 or spark
...3000,check engine light flashing and engine sputtering This error code indicates that the exhaust overhead cam is out of position. The belt/chain or sensor has a problem. Hope this helps? OBD II Code ...
2,158 questions posted
Usually answered in minutes!
818 Questions
485 Questions
212 Questions
74 Questions
42 Questions