...tank: 30 - 50% is recommended. Time required: 16 minutes or less after started the engine. Drive cycle pattern: One trip monitor (from start to ignition switch to "LOCK" (OFF) position. Well be ...
...replace tank selector valve at same time (there both about due) shield your eyes when dealing with this device as gas sprays out when removing it a note : observe fuel level while driving on both ...
Question about Mitsubishi Eclipse
...tank gas stops where is the fuel tank selector valve located on my 1995 ford f150 w/ 5.0 ? when I switch to the rear tank the engine does not get fuel....it runs fine on the front tank There is no ...
Question about Cars & Trucks
...gas motor died and won't run when I switched fuel tanks? Selector valve or fuel pump? Can I bypass selector valve? Very inexpensive part, recommend replacing the fuel switch valve. You can buy it at ...
...Gas Tank Selector Valve How to Clean and Repair it. - YouTube Could be fuel tank selector valve above links Below link has a wiring diagram for 302 which on my laptop I had to zoom in to 220% to try ...
...gas in one tank, I switch to the other tank. Then when I run out of gas in that tank, I can switch to the "empty" tank and have 1/4 tank of gas. SO ON AND SO ON! I had the same problem with my 89 ...
...tank selector valve.. When i turn on the key to aux. gas shoots out the top of the unit... Should there be gas in or above the diaphragm? JP There was a recall of sorts on the switching valve under ...
gas tank. When the you flip the selector switch at the dash, you can hear a click from the transfer switch on the frame. The rear tank is full of gas. I'm sure there isn't a pickup problem in the rear
gas tank. mine's been replaced 3 times on the front tank and is broken again. the brass float fills up with gas and sinks. the sender simply grounds the guage through a variable resistor operated by a
Question about Ford Cars & Trucks
...fuel pumps,relays,regulator,fuel press. valve,still won't start. Gas guage and tank selector switch gets volts for 2 secs. in 'RUN' then only pulsates my test light. check ECM mod on side of ...
380 questions posted
Usually answered in minutes!
696 Questions
644 Questions
360 Questions
344 Questions
319 Questions