2004 Mitsubishi Lancer "replace cooling fan" Questions

Ad

...cooling fan stays on? Probably the Temp Sensor contact which make when temp is high is permanently made. It is a small box next to the fan. Too much hustle to repair, just replace it, that is if you ...

Ad

Question about Mitsubishi Lancer

1 Answer

...cooling fan diagram Its just a relay they are cheap try replacing it , if that does not work,look for a bare wire and replace it. Or simply run a wire from fuse box that is key on hot only into the ...

Ad

Question about Mitsubishi Lancer

1 Answer

...cooling fan relays are located, you can eliminate this step easily. Take a known working relay (rear defrost or something not essential for starting) and replace the fan relay with the known ...

...replace the fan control unit? I don't think I have issues with coolant temperature sensor because I don't have errors for it. Any suggestions? Sensors do not always throw codes if they are close to ...

Question about Mitsubishi Lancer

2 Answers

...and letting car over heat like a 8 dollar fix replace it and the gasket too for thermostat Also check an make sure the cooling fan or fans are operating it might have a bad sensor , relay or

where to find instructions on replacing the dual cooling fan in a 2004 Mitsubishi lancer ralliart Recommend purchasing a repair manual at an auto parts store.

...cooling system. Drain the coolant, flush the system, replace the thermostat, and fill with a 50/50 mixture of antifreeze and distilled water. Bleed all air from the system. I am assuming you are not ...

...replace the switch relay (I think) for 2 fans that have freaked out and won't stop running whenever the car is on. They're to the cooling and air system, one on each side of the car. I heard it's a ...

Question about Mitsubishi Lancer

1 Answer

...Cooling/Heating as the knob is stuck on Max Cool. 3. The Blower Air throw is less as compared to friends' cars. 4. I want to fit a free flow air filter. What modifications are required for the same? ...

Question about Mitsubishi Lancer

2 Answers

replace the resistor with an electronic type, it will have to be rated for quite a few amps - probably about 5 amps at least (= 60 Watts) and that is a big resistor. The wire coils are better and they

Not finding what you are looking for?
Cars & Trucks Logo

394 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Mitsubishi Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...