purge valve is not opening when it is commanded to do so. The MOST COMMON cause of this code is either refueling the vehicle with the engine running or a fuel cap that is not installed properly. Check
I installed new rear shoes,drums,&wheel cylinders on both sides of my 2000 caravan, the passenger side bleed out fine but I can't get any oil flow out of the drivers side. I used a vacume pump and
Question about Dodge Caravan
...Install the EVAP canister purge valve to the bracket. Position the EVAP canister purge valve with bracket to the cylinder head. Caution: Refer to Fastener Caution. Install the EVAP canister purge ...
purge bracket. Install the EVAP canister purge valve and bracket. Tighten the purge bracket nut to 71 inch lbs. (8 Nm). Connect the purge pipe to the EVAP canister purge valve. Connect the vacuum pipe
...Install Replace Vapor Canister Purge Valve 3.4L ... ? 2:42 https://www.youtube.com/watch?v=IPKnoxJCIWk Jul 9, 2014 - Uploaded by 1A Auto Parts ...
...Install Replace Vapor Canister Solenoid Purge ... ? 2:14 https://www.youtube.com/watch?v=TZ6ZB_acC9w Sep 16, 2014 - Uploaded by 1A Auto Parts ...
...purge solenoid is located in the engine compartment near the brake master cylinder. Disconnect electrical connector at solenoid. Disconnect vacuum lines at solenoid. Lift solenoid slot from mounting ...
...purge valve electrical connection. Tag and disconnect the vacuum lines from the valve. Remove the valve from the car. To install: Install the valve and connect the vacuum hose. Attach the valve ...
...evaporative emission canister purge valve assembly from fuel vapor canister and throttle body. To install, reverse removal procedure.
...purge valve solenoid per engine light codes. I know it should be close to the manifold and fire wall. I haven’t found any schematics to show me where to find it. I need to replace the canister purge ...
578 questions posted
Usually answered in minutes!
2,271 Questions
1,496 Questions
1,337 Questions
1,299 Questions
1,150 Questions