1997 BMW 318 "90 degree turn cylinder head" Questions

...90 degrees turn leave 20 minutes stage 3: 90 degrees turn leave 20 minutes you have to leave them this length of time so as not to put to much strain on the head in one go...hope this helps please ...

...at 65. After 1000 miles turn 90-degrees. 12pt (m12) 1st 29 lb-ft, 2nd 43, 3rd turn 90-degrees, 4th turn 90-degrees, warm engine and turn another 90-degrees. After 1000 miles turn ANOTHER

...would tighten as follows; 19 nm then loosen 90 degrees, tighten to 29 nm, mark bolt heads with paint and turn each bolt 20 degrees until 90 nm and then continue tightening to full torque. Regards ...

...90 degree turn, or a 1/4 turn......
3rd stage 90 degree turn, or a 1/4 turn.......

Camshaft bolts inlet and exhaust share the same torque settings 120 Nm

Cylinder head bolts MUST ...

...Nm (44 lb-ft) following the sequence shown. After tightening, turn all bolts 90 degrees, in the same sequence. Complete bolt tightening by turning them an additional 90 degrees, in the same

...10 6 2 3 7 9 5 1 4 8 Note: Tighten the bolts in three steps. First, torque all bolts to 30 Nm (22 ft-lbs), then turn all bolts an additional 90 degrees, and finally turn all bolts another 90

...turn each bolt an additional 90 degrees. Originally Posted by norvelplagbao52 1993 saturn sl2 1.9 dohc cylinder head torque specs and sequence Cylinder head bolt tightening procedure: CYLINDER HEAD ...

...for cyl head, big ends, mains, flywheel, thanx Cylinder head bolt are 60 nm then a 90 Degree turn, Main bearing bolts are 30 nm then 180 degree turn and connecting rods are 30 nm then 90 degree

...65 ft lbs 4th step do not use torque wrench but turn 90 degrees Bolt torque after 90 degree turn should be over 90 ft lbs, if not replace bolt. 2008 dodge grand caravan 4.0 cylinder head bolt's ...

...90 degrees Step 9: Turn all bolts an additional 80 to 90 degrees *** CAUTION *** engine uses Torque To Yield head bolts (TTY) that permanently stretch during the initial installation. New head bolts ...