2001 Oldsmobile Aurora "replaced battery brake lights flash" Questions

...brake and battery light are on I was driving home last night and I noticed that my battery and brake light started flashing. Then continued to stay on. Before the dash lights came on, I was driving ...

...that flash are the battery light, the door open indicator lights on the dash and the brake light - all at the same time. I had the battery replaced since mine was two years old but this didn't fix

...battery light and brake light flash even though I have changed alternator, clutch and added gearbox fluid , recently serviced also ??? Check for a ground cable disconnected.possibly when you replaced ...

...battery,door and brake warnning lights are on and my battery is dead over nght bad door switch, dose your dome light go out when you close the door? brake light can be a tail light out, put 4way ...

...BRAKE AND BATTERY LIGHT ON Any one up there can help. I just installed a rebuilt 22RE motor on my 91 Toyota 4x4 3 days ago and 2 hours ago the brake and battery light came on. It flashes when I turn ...

...battery with brand new one. Immediately ABS light comes on ESP/BAS error & Airmatic... All have never came on before. Lights still flashing after locking the car... is this a door sensor problem? ...

...battery. Was told it was my stoplight switch at the brake pedal. Have replaced the stoplight switch 3 times & it only fixes the problem for a short time until the brake lights start flashing again. ...

had the same issues with my 05 focus, 2.0 ses auto. Dealership troubleshoot and said bad battery , though it was only 16 months old. Replaced battery and have not had problem since (over 4 months ago

replaced the battery and said everything was fine, but driving it around later that day the lights were flashing/dimming again, and car almost stalled when I turned air on! Sounds like your alternater

...flashing,I have change brake pads full up brake fluid bit still flashing can someone help how to reset the light remove the negative battery cable for five min. and replace should clear old codes ...