2000 Oldsmobile Alero "three flashing red lights gas" Questions

...have the red button, you turn the key on, push the gas pedal to the floor three or four times, and the light should go off.The method for your model should be in the back of your owners

...three ways of turning off the oil light. The first is rather easy. If you open the glove box and look in to see if there is a button for your reset. If that is not there then when you open the driver ...

...red reset button until the "change oil" flashes, then hold the button down until it clears from the dash. This should take care of it. turn key on engine not running, depress gas pedal to floor three ...

...three times within five seconds. If the Change Engine Oil light is flashing, the system is reset. The light will flash for up to 30 seconds or until the ignition is turned off. If the light comes on ...

...light starts flashing, then let go and hold it again until the three lights-I think tire pres., oil and ??? they are now reset. Just keep trying if U have too. What about an owners manual?? Good

...three clicks, the Relay is fine. DO NOT REPLACE IT. Turn ignition to ON (but not to START): Click 1 Check Engine light goes off: Click 2 You now turn the key to START: Click 3 The most common symptom ...

flashing security light, just a solid red security light. The learn procedure does not work for me when the security light is on. The car will not start, only turns maybe a quarter rotation, and stops

...flashing and the ECU will keep all stored codes and the check engine light will remain on. For V6: 1. Turn the ignition switch on, but do not start the engine. All of the lights in the dash should be ...

...red RESET button, near the top of panel, with the key turned to ON position and car NOT running, push the RESET button until change oil light flashes, let go of the button and hit it again, this ...

...flashing. Any ideas what is going on It sounds like your alarm is getting triggered and causing the car to go into the 'immobilizer' condition. Look in the manual for a way to disable the alarm ...