...to take a c.v shaft out of a 2000 alero so i can change the transmishon Assuming that you've already removed the hub assembly a flat bar works nicely to pry the stub shaft from the tranny. Thanks, ...
...n outer joints and it still does it.? Can it b a stub shaft? Tranny fluid? Or what? Please help . New wheel Barron's today's brakes Ty rods all brand new please tell me what to do! Check motor
Question about Oldsmobile Alero
...stub shaft off a 1984 turbo -350 transsmission stub shaft how to remove and replace it with 2'' longer stub shaft I have 2 transsmission 1 stub shaft is 2" longer then the other stub shaft is affixed ...
Question about Cars & Trucks
how to take stub shaft out of cv shaft on 2008 huyndai sanafee To remove the stub shaft, just remove the inner CV boot and the spring retainer and the entire tulip and stub shaft will come off
Question about Oldsmobile Alero
right drive shaft loose feeling where splined female goes on maLE TRANNY STUB SHAFT front right drive shaft is loose feeling where female end goes over male stub shaft from tranny cv joint is bad.
...stub shaft out of the transaxle? That is the kind with a roll pin to hold the axle onto the stub shaft. Use a hammer and proper sized punch to drive out the roll pin. It fits in a hole in the center ...
...stub shaft retaining ringon transaxle assembly. insert small pry bar between transaxle case and inner CV joint by prying on it.remove strut assembly to steering knuckle bolts remove top of steering ...
Question about Cars & Trucks
The shaft stub was left in the transmission when removing CV axle on 04 montana. How do I remove or remove cog from new axle? The "stub shaft" should have come out with the axle.
Question about Mazda Cars & Trucks
is the size and thread of a Mazda rustler 2000 model rear stub shaft The rear stub shaft on a Mazda Rustler 2000 model has a diameter of approximately 1.22 inches (31 mm) and a thread pitch of M20x1.5
Question about Subaru Cars & Trucks
...shaft should bolt to the Trani Stub with 6 (or8) allen keyed bolts. If I had to guess, I think the mechanic may have ruined the seal at the half shaft bolt up point. Maybe he was a bit ******* the ...
1,543 questions posted
Usually answered in minutes!
1,478 Questions
1,272 Questions
1,097 Questions
830 Questions
662 Questions