1999 Oldsmobile Aurora "positive lead attach starter solenoid" Questions

Ad

Question about Oldsmobile Aurora

3 Answers

...positive + lead on battery then trace it down to where /the component the other end of cable attaches to this will be the starter solenoid which is attached to the actual starter motor including ...

Ad

Be careful not to touch the two post together on the solenoid or it will start right up on you! One lead goes directly to the starter and the other goes to the positive lead on the battery. Good luck

Ad

Question about Oldsmobile Aurora

2 Answers

...positive + lead from battery make sure nuts secure cables ? ok ? now with ignition off reconnect the battery leads to battery in this order ! connect positive 1st and secure then connect negative ...

Question about Oldsmobile Aurora

1 Answer

...lead from the solenoid by loosening the retaining nut ... Fig. 7: ... then remove the two attaching screws and separate the solenoid from the motor housing To install: Inspect the solenoid plunger ...

Question about Oldsmobile Aurora

1 Answer

...lead from terminal M on the starter motor. Using jumper wires, connect a 12 volt battery to the starter motor so that the negative battery terminal is attached to the starter motor housing and to ...

Question about Oldsmobile Aurora

2 Answers

LEAD CONNECTED TO THE STARTER SOLENOID IS HOT AT ALL TIMES. Removal Disconnect battery ground cable (14301). Raise vehicle on a hoist. Refer to Section 00-02 . Remove attaching bolts and starter motor

...positive+ lead to from battery also there should be another lead to also attach to same terminal this one supplies power for vehicles electrics etc ensure you secure these with nut ok? now the third ...

positive battery cable away from the battery, it should lead you to the starter solenoid, which is mounted on the starter itself (you may have to crawl under the passenger side of the car to locate it

...starter to the vehicle, then attach the wiring. Position the starter, then secure using the lower starter bolt. Tighten to 66 ft. lbs. (90 Nm). Fig. 1: When installing the starter on the 2.4L engine, ...

...positive on the battery and using a screw driver trapped in the jaws of the other end so it will make a connection and tap the screw driver tip on the lead side that is opposite of the battery side. ...

Not finding what you are looking for?
1999 Oldsmobile Aurora Logo

529 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Oldsmobile Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...