...hard. before u start connect the neg. side of the battery. open the gas cap to help to let the or some of the pressure out of the tank.remove the fuel pump cover and unplug the electrical connector ...
hard (sometimes you have to work it for a little while) and it pops the line connection loose. Make sure to remove the gas cap and wear eye ware when doing this. Gas in your eye is not a good feeling.
...unscrew it and place a rag under while you push the valve with a small screwdriver, do not push too hard or you'll damage the valve. once you push and release the valve, turn the key to the ON ...
...gas tank and replace it manually. It isn't as hard as it sounds, I've done it. Just be sure to disconnect the level sensor plugs from under the rear passenger seat.. The tank is held in place by two ...
...hard but since your car is 8 years old you may want to find a garage who can do this job for you. you have to get the car on a lift and if the gas tank straps break your going to have to weld new gas ...
...hard to replace just the fuel filter? Stand in front of the Camry and locate the fuel filter.Open the hood of your car. The fuel filter on a 2003 Toyota Camry is located in a black container near the ...
...unscrew it. It should only be on hand tight...but will feel tighter. There is about less than a half a quart in it. Remove it. Now put the drain plug back on the oil pan. Get the new oil filter and ...
...unscrew the fuel tank cap to release pressure in the tank before working on the tank or lines. Disconnect battery negative cable. The fuel filter is located beneath the center of the car near the ...
Question about Mazda Protege
hard to get off now and the pump won't suction on when I try to put gas in. 1. Unlock the gas cap. Slip the key into the slot on the center of the cap with the teeth toward the outer circle. 2
875 questions posted
Usually answered in minutes!
373 Questions
369 Questions
284 Questions
255 Questions
249 Questions