2001 Ford F150 Styleside SuperCrew "replace rocker arm 2" Questions

...rocker arm to fall out of place and the valve could never open...try unplugging 1 coil pack at a time while running and listen for a change in the way it runs,if there isnt a change then its probably ...

...rocker arm or valve was loose, especially right at 1100 rpms with load, it only makes the sound upon acceleration. Tom Tom: If it is a spark knock there may be a couple of things to check on this. ...

...Rocker Arm Fulcrum Bolts18-25 ft. lbs. Thermostat Housing-to-Engine BoltsThrough 19879-12 ft. lbs. 1988 and up12-18 ft. lbs. Timing Chain Cover Bolts12-18 ft. lbs. Valve Cover Bolts10-13 ft. lbs. ...

Replace/Remove Dec 30, 2006 - For the 2.0L engine: Rocker Arm Stud 33-40 ft. Lb Rocker Nut 11-18 ft. Lb For the 2.8L engine: WITH NON-ADJUSTABLE ROCKER STUDS Torque ... 1997 Chevy Cavalier Rocker Arms

...rocker arm. I read you dont have to adjust hydraulic lifters, however how tight should the nut be that fastens the rocker arm? Turn it down until there is no play in the arm, then 1/2 turn

...rocker arms I didn't mess with anything else! Also I did do 3/4 turn on the new rockers but before with the stock ones I went 1/2 turn. This is a small block chevy built up kind of, big cam, new 1.5 ...

...to let it click again and then tighten again until it just stops clicking. Do this on each rocker, and then add 1/2 - 3/4 turn to all. This is messy but more accurate. Replace the oil that was

...rocker arm. Replace any that are scuffed, pitted, cracked or excessively worn. Inspect the valve stem tip contact surface of each rocker arm and replace any rocker arm that is deeply pitted. Inspect ...

...rocker arms on both sides thank you very much for any help thanks again merry Christmas Yes keep the rockers arms in line and put the back in the same position, same side. Just a note. I usually ...

...rocker arm to nearly come off? After replacing my intake gaskets due to vacuum leak and finally getting my engine to start.. a clicking noise appeared and found out my rocker arm nearly fell off the ...