2006 Dodge Stratus "pressure" Questions

of my drive. only dims or goes off after reaching 2000 rpm. had oil changed 2 weeks ago. engine oil pressure may be low remove oil pressure sending unit and install a pressure gauge check for pressure

have a 2003 stratus with intermittent A/C works great when on, where is the pressure sensor located?, that may be problem On this Chrysler product they have an A/C Transducer located on the high ...

A/C builds up too much pressure and pops off high pressure relief I have replaced the expansion valve the high pressure hose, high pressure switch, and the Receiver dryer While driving the car it ...

...up after a cold start? There could be a couple of problems causing the issue. You could have an oil pressure pump or pump pressure regulator sticking. I would have a mechanical oil pressure gauge ...

oil is not low but oil light is on This may be an oil pressure light in which case you need to inspect and or replace the Oil Sending Unit. Located towards the bottom of the engine. When these go bad ...

have to follow the power lines to find it. I would check the relay first. Then check fuel rail fuel pressure. It may be faulty fuel pressure regulator or a sensor. Is your check engine light on? If so

...and off it looks like the oil can light but I just changed the oil? What should i do? Check the oil pressure at the oil pressure sending unit (remove it first and install the oil pressure gauge). If ...

...you get this fixed.First step is to check your oil level. If the oil drops to low so will the oil pressure and set this light off.If your oil level is fine then the usual cause is the oil pressure ...

whats the pressure suppose to be nedd to know what fuit isel pressure is for If you mean; What is the fuel injection pump pressure? This would be in a workshop manual and not readily tested without ...

...with engine speed > 1000 RPM, the TCM (Transmission Control Module) momentarily turns on element pressure to the clutch that don?t have pressure. For this to be activated, the switch must be