Question about Mazda MAZDA6
...Temp gauge needle Mar 14, 2013 overheating problems Jun 5, 2010 Temperature Gauge May 22, 2010 More results from forum.mazda6club.com Temperature gauge going up and down - CarGurus www.cargurus.com > ...
...temp gauge on cold, ext temp 100 deg (outside temp below 95 deg), sometime high idle, sometime temp gauge will be working but show over heating when at a stop. Will turn car off & restart. Problems ...
temp gauge shows hot quickly Just turned cold....turned on heater.....no heat......temp gauge shot up quickly. Thermostat stuck? Where is it located? EITHER THE THERMOSTAT OR U ARE REALLY LOW ON ...
Question about Mazda MAZDA6
...temp gauge goes up while driving at 60 miles the gauge shows overheat might blow some heat for 10 minutes then back to cold air Click the link below ...
Question about Mazda MAZDA6
...gauge went way up, heat is turned on and only blowing cold air. Put anti-freeze into the radiator and the overflow and the temperature is still going above normal and turning the heat on will still ...
Question about Mazda MAZDA6
...in the dash what the temp is. The other 2 ideas would be a bad gauge and a bad wire/cable from the sensor to the gauge. There is not much else it could be if in fact the reading is
Question about Mazda MAZDA6
...temp gauge reads hot, you could have a problem with the instrument panel. Both gauges get power from the same circuit, but each gauge is grounded by its own sending unit. If the temp gauge is reading ...
Question about Mazda MAZDA6
...temp gauge showed the motor was running cold. nothing changed. In Sept I had the water pump replaced because it started leaking. M anti freeze was low. Added and tried bleeding air from screw on top ...
...Jeep is moving but it turns cold when I stop for a light. Then when I start moving, it heats up again. The temp gauge shows normal. the heater fan is dead. blower. check the heater fan fuse for
...but temp. gauge shows cold Hi, the problem started when I changed the block and pistons on my 1974CC 2c engine. The needle sticks below 1/4 of the gauge Please help. Check sender and
477 questions posted
Usually answered in minutes!
738 Questions
454 Questions
386 Questions
74 Questions
48 Questions