2002 Volkswagen Jetta TDI "starts few second" Questions

...starts for a few seconds. anyone have and ideas. the car starts great and runs good for about two seconds and then it shuts off, every time. HI You have to see clouses dealer. Your antitheft it is ...

few try`s it starts and die again then it starts to idle then after a few seconds idleing and the temp starts to move the car is fine the hole day. You need to change engine coolant temperature sensor

2007 Volkswagen Jetta 2.5 Wolfsberg edition 5 speed with brand new tires. I started the car this morning and the MIL (malfunction indicator light) started blinking and the car was running extremely ro

...second to third. The grabbing is not consistent, and seems less likely if I slip the clutch a little. At the same time, my gas pedal will bounce back and forth slightly a few times. Any suggestions ...

When starting my 2003 jetta runs for 2 seconds and cuts off? I used the car it ran fine and the nest day it was damp and rainy and when I tried to start it, it would only run for 2 seconds and shut ...

...starts to over heat at 95, 100 5o 110 degrees when I accelerate (but never gets the red line). I cheked the coolant, there is no leak, I cheked the fans, they run perfectly at the first and second ...

...starts and dies in about 10 seconds. Take the ignition key out and put it back in again to start and it will die again in about 10 seconds.... The dealer found that the fuse of the primary fuel pump ...

...starts up runs a few second shots down 2001 jetta starts up runs a few second shots down My Pop's 2002 VW TURBO JETTA leaks oil inside exhaust. What possibly could be wrong? turbo seals leaking. they ...

Screaming noise when driving initially but stops if the car is idle for a few minutes If I start the car and let it idle for more than 2 minutes there is no noise but if I start driving right away she

starts for a few seconds and then shutsdown. could the relay be bad or is it one of the signals comming into the relay that is causing it to open? And is there a way to test the relay? Any suggestions