100 amps fuse at the + battery post cable was connect to alternator for recharging your battery and give power to other items when car was running..Below that post, the middle cable was connect to the
Question about Mitsubishi Lancer
...100 amp battery fuse on my '01 Nissan X-Terra I need 2 know how 2 remove and replace the 100 amp battery fuse. When I pulled on it with my hand it shattered. The 80 amp fuses simply pull ot. Is the ...
...100 amp main fuse under the hood. I replaced the 100 amp fuse and hooked the battery up again and sparks flew from the negative terminal and fried the 100 amp fuse again. What am I doing wrong? At a ...
100 amp battery fuse assembling I blew the 100 amp fuse on the positive battery terminal so I bought new fuse, but I don't remember well how to hook up with other two lines. I think each line goes to ...
100 amp fuse, and does not have a key fob type alarm. The ignition key is a chip key, but the door key is not. We have tried the 15 minute disconnect, and the turning the key in the ignition sequence,
...100 amp fuse now it will not crank check the ground wires first to see if it is lose. If you know how to use a multimeter and check the voltages of any wires you see would short out the 100 amp fuse ...
...100 AMP ALTERNATOR FUSE TO CHANGE IN 1998 TOYOTA CAMRY 2.2 LITER not taped in harness it is bolted into fuseblock on outside of fuse block are 4 little locks holding in part of fuse block using small ...
100 amp fuse blew. thought it was the alternator so swapped it still same problem. If i pull the battery feed exciter wire off alternator fuse doesnt blow you may connecting it wrongly , please check
...100 amp fuse on my 05 toyota tacoma You need to pull the fuse box out, and loosen the fuse holder panel. This is harder than it sounds, trust me. The 100 amp fuse is bolted in, 10 millimeter bolt. ...
948 questions posted
Usually answered in minutes!
997 Questions
213 Questions
209 Questions
136 Questions
57 Questions