2000 Mitsubishi Galant "current reservoir levels" Questions

current fluid level. Do not add any fluid if the fluid is already at the "Full" line; overfilling the reservoir can damage the transmission. If the measurement is between the "Full" and "Add" lines or

reservoir for servo pump. Follow-on work, 6-cylinder Fill up coolant. Warm the engine until the thermostat opens. Switch engine oft and check the level. Re-fill if necessary. Check for leaks. Check in

...one up at the auto parts store when you get the 50/50 mix to check the freeze protection level you currently have. Theoretically, you only need to add the mixture to the reservoir and the cooling ...

my car currently has an issue with the heat and it comes on and goe off randomly. I was told that this is most likely due to the thermostat being stuck shut. But today the car' temp light came on and ...

...to windscreen washer is intact. Furthermore, you may also need to check the wiring for flow of current at lever end (handle on the steering wheel) and wires connecting to pump on the water

levels. Radiator, Hydraulic brake and clutch reservoirs. Check air filter. Make sure battery is charged and will hold a charge. Top up fuel tank. Check all lights. Signal, brake clearance, hi/lo beams

...current engines operate best at temperatures above the normal boiling point of water/coolant. When the system is pressurized, the boiling point is raised so coolant doesn't boil over. If the radiator ...

...reservoir. The fluid level ws low because the brakes were worn. Anyway I added fluid and the brake light went out, but within minutes the check engine light came on. Here are the codes: P2195 - ...

...current time. You do the above following information to check your fluid and a good rule of thumb is to not work under a car while it's running. You can check the level by the old forefinger or pinky ...

...current signal coming from the Powertrain Control Module (PCM). This signal is a function of various inputs. Refer to Electrical Diagnosis for further information and diagnosis of the cooling fan ...