2000 GMC Sierra "rear end" Questions

...rear end What are you trying to do? Setting up rear end gears takes special tools and skills to set up so it runs quietly. Most rear end failures gets entire rear replaced with used one, due to cost ...

rear end is locked. The left rear wheel spins in forward and reverse. The wheel locks up even without applying the brakes. thanks Boomer okay you had brake work done!!! "THINKING" that was the problem

...rear end You'll need to remove the rear end cover, remove the pin in the center pumpkin, push axle toward the center of vehicle and remove the axle clip, pull out axle. You may need a bearing puller ...

popping noise in rear end when turning. Acts like 2000 GMC Sierra 4x4. Popping noise in rear end when turning. ur elbow in the driveshaft is bad

What are the stock gears in the rear end of a 2 wheel drive 1996 GMC sierra 1500 extended cab/ most all of these trucks came with 3.42 gears it most likley is a 373 rear end

...rear end from the junkyard and try to get the same one its gonna cost me more just cuz its a limited slip posi.? So then would it be possible to get an old one that has drum brakes a my 99 gmc sierra ...

...service and adjust rear brakes. If not, go to the drive shaft, check the u-joints and/or jack up the rear of the truck and rotate your tires by hand to see if there is a clunk in the rear end

...the rear end cover off inside you will see where toyr axle shafts into the diff case you will need to pull out the rod in the middle then you can push the shafts in far enough to get the c locks ...

...the transmission cause this sort of problem? Thanks. More likely to be a rear end issue. If the brakes have been checked I would have your rear end checked. Could turn into a very dangerous