Relieve The Fuel Pressure to change the fuel filter on a 1991 buick LeSabre? Remove the fuel pump relay and disconnect the battery first. Loosen the hose clamp on the fuel rail a little at a time very
location fuel filter Here's how to replace.Here's another link on how to relieve the fuel pressure.
...Relieve fuel pressure(push in valve under plastic cap right side beside alternator on rail. Remove the torx screw holding regulator bracket. Pry out and replace "O" ring, reassemble. If its not the ...
...relieve the pressure at the test port on the injector fuel rail (under the plastic engine cover), again using a rag to catch the fuel spray. Wear safety glasses, and only do this when the car is ...
...relieve the fuel pressure. Start the car and pull the fuel pump fuse oe relay. let the engine run 'till it dies. The fuel pressure should be gone. The '00 Le Sabre has and access hole in the trunk ...
...Relieve the fuel system pressure. Twist the quick connector 1 / 4 turn in each direction to loosen any dirt that may have accumulated in the connector. Use compressed air to remove any dirt in the ...
Relieve Fuel Pressure Disconnect negative battery cable Raise vehicle on hoist Remove Fuel Tank Remove Fuel Gage sending and pump assembly by turning cam lock ring counterclockwise. Lift assembly from
...Relieve the fuel system pressure. Drain the fuel tank. Fig. The fuel pump service cover is located in the luggage compartment under the spare tire-Park Avenue shown; Bonneville and LeSabre similar ...
...end by a pressurized fuel lines. If you are about to change it you must relieve the pressure in the fuel line before you start, and it is also recommended that you disconnect the neg. battery
relieve the fuel pressure from the system before you attempt to disconnect the filter. the older these cars get, the more brittle the connectors can be, so be careful when working with the connectors,
1,276 questions posted
Usually answered in minutes!
1,731 Questions
1,603 Questions
1,084 Questions
904 Questions
897 Questions
