2000 Buick Park Avenue "remove back box mini" Questions

...back seat can be removed by pulling up on the front (slide your fingers under the front side of the seat and pull up.) There will be a 3" square black box just about the middle of the seat area. This ...

...remove. On some cars in the box by the fuses, you will see a little plastic tool like small tweezers plugged in like the fuses.It is used to grab hold and pull the fuses out.If there is not one, I ...

...Remove the two metal screws on the right side of the air filter box. They're located along the seam where the lid meets the bottom of the box. Slide the lid to the left about a half inch; it won't go ...

...the top of the trim panel pops out has clips on the back side pry out with a flat blade screw driver and a rag to not damage dash then youll see the radio mount screws remove these and unplug ...

...lifting eye and to the cross brace over the radiator to rotate the engine. Then remove the ignition coil pack to access the back plugs. You'll probably need a universal and an extension. Good

...back of the box, then remove the gear box. But you have to support the gearbox usually with a good shop lift jack. Remove the gearbox crossmember support. After you have taken off the battery leads, ...

...back to remove fuses and by the way the fuses used are not your standard size fuses, not even the mini fuses, no they are called micro fuses and most places dont have them in stock and special order ...

...back wiper and washers ok too. Just front wipers - is the likely problem a relay? You actually have a wiper relay this should assist you swap with another see if functions Service and Repair The ...

remove the knee panel- three screws, get a flashlight, and look up while laying on your back on the floor, the get an 11 year old or some one with tiny hands to push the plugs back on, or you can take

...remove the "sub frame mounting bolts" the miny has 4 rubber mounts that hold the engine and gear box in and the hole sub frame can be droped by taking out 8 bolts,, if one of the rear mounting bolts ...