...control is not a sensor on the air horn.Why do people who have no clue bother answering? The idle speed is controled by the throttle body which allows a specific amount of air to flow into the engine ...
...scan and code p506 idle control system rpm low came up...any common solutions? What does the tachometer read when you are at idle? the idle speed may need to be adjusted, it should be around ...
Question about Mitsubishi Endeavor
...speed, like in a parking lot. I hear a knocking sound coming from under the wheel wells in the rear end when I make a small turn or go over a small bump. How can resolve this issue? Thank you. There ...
...If OK, use starter fluid and spray along intake manifold gaskets with engine running. If engine speeds up, there is a leaking gasket. IAC deals with idle. Does the car idle smoothly? If not, ...
speed control motor generally controls your idle when everything else is working properly and it works hand in hand with the Throttle position sensor. You may want to check the connectons & wiring
...speed - just enough to get you to your home or service agent.What the "N" light flashing means:i) One flash per second (1Hz) - the computer has detected an ...
...is under the dash on the passenger side, remove the panels to see. Also replace the blower motor speed controller while you are there, it is mounted to the blower motor
My 2008 mitsubishi endevor stalls when driving The very first thing that you need to do is have the engine control computers fault codes checked. The idle speed is 100% computer controlled.
ac vents not blowing air Its either a bad blower motor or a bad speed resistor pack that controls the fan speeds.
72 questions posted
Usually answered in minutes!
739 Questions
190 Questions
94 Questions
77 Questions
4 Questions