2008 Pontiac Grand Prix "engine guard" Questions

...guard (if equipped). Refill the cooling system with the specified type and amount amount of engine coolant. Install the air cleaner assembly. Connect the negative battery cable, then start the engine ...

...Reattach the accessory drive belt with the drive belt guard. Refill the engine's cooling system with coolant. Start the car and check for leaks when the engine reaches normal operating

Timing Chain I need to replace the timing chain on a 1996 Pontiac Grand Prix V6 engine, Automatic Transmission dont kill the messenger but here's a link how to do it and it's a fairly big job .good ...

...guard in the fender well. Looking forward into the fender well you'll see the windshield washer reservoir (whiteish plastic container); the pump motor is pushed into a hole in the container and ...

engine), is about 8" long, and comes from a black cylinder shaped object. Curious...Does coolant only get pushed through this hose occasionally? Anyway, I replaced the hose, topped-off my coolant, and

...engine ... does this 'sump-guard' have to be removed in order to reach the oil drain-plug? Any advice on how to remove and refit this heavy-looking sump-guard would be much appreciated. Thanks and ...

...that hold the plastic on, I think, 1 on side of trans and 1 behind starter, between starter and ...

...engine from guard to guard, secure it, it will support the load and drop the lower susp. when removed lower the support chain until you get the angle to remove the trans, or just drop the whole lot ...

...is one video that might help. Also the Kia Forums are a good source of information. There are two engines in the Sportage, a V6 and a straight 4, so that may be the difference in metal or plastic. ...

engine is making a weird rubbing noise, could it be the belt? the belt may be rubbing against the plastic guard...look around the guard area for very small particles of rubber...if none found, then it