2008 Chevrolet Uplander "replace rear exhaust manifold 2002" Questions

...replace a rear after oxygen sensor for 2002 toyota rave4. where can I fine a drowing pattern of it. thanks you can go to autozone.com and register for full free online repair manual, Register, login, ...

...replace an EGR valve and where is it located? it connects to the rear exhaust manifold by a metal flex tube, that goes up to the intake, search google for a picture, and you should find it on the top ...

exhaust system. It will have a chord coming from it and heading to the engine. It will be plugged in at the rear of the engine. This is the more expensive O2 sensor. Just make sure not to cross thread

rear bolt/stud/nuts are rusted and missing. This causes a slight leak of exhaust gases that sounds like ticking. I'll also bet it's louder when the motor is cold. My research indicates that just about

...rear manifold. Test drive it with the exhaust unbolted. If the power is restored replace the cat. You can also try unplugging the MAF sensor and see if it drives any better. Reading the codes that ...

...REPLACE DRIVE BELT BEFORE IT BREAKS. IF CAR SMOKES HEAVY WHITE YOU A HEAD GASKET LEAK.IF CAR SMOKES BLUE SMOKE ALL THE TIME YOU HAVE WORN OUT PISTON RINGS OR VALVE GUIDE AND VALVE SEALS. seized ...

...exhaust manifold (did they say bank 1 sensor 1?),you can start by replacing that sensor,i would check the intake for leaks ,the gm 6cly. are known for bad intake gaskets,you will see oil coming out ...

...2002, engine lite came , took to parts store, put on diognostic machine , this code came up. wat does it mean? Bank 2 sensor 1 Air fuel sensor heater circuit. This sensor is NOT an O2 sensor, though ...

...Rear caliper bolts: 25-38 N·m (18-28 lb·ft) Brake rotor bolts: 72-90 N·m (53-66 lb·ft) Tire Bolts: Lug nuts: 100-120 N·m (73-89 lb·ft) Important: Always use a torque wrench to tighten bolts to the ...

...replace rear O2 sensor on 2002 mazda miata The sensor is easy to locate but the connector appear to go into some kind of housing and I can't see how to access it you have to remove the exhaust ...