2008 Chevrolet Uplander "problems" Questions

2006 UPLANDER HAS STEERING PROBLEM... CLICKING NOISE when I drive slowly.. noise like (tik tik) This is from long time.. I went to my mechanic.. He tried to fix it twice but still same problem.. How ...

abs light on if both the abs and traction control lights are on the problem is the bearings need to be replaced.happen to me and had to change both front bearings.problem solved. Same with mine. ...

i am getting p0030 , p0036. po102 and p0443 on my 2007 chevy uplander , I think the first thing I would do is clear the codes and see how many come back after you drive it.Code 30 and 36 are for the ...

Uplander 2006 with a reading on the display that say reduced engine power what can I do to fix this problem ? You can many times clear this error by disconnecting your battery for a few minutes...but ...

...it a lot to start it. Not sure if others have the same problem, not may car just researching the problems. No codes set in the computer. Ignition module changed out. Problem still there. check the ...

Chevy Uplander 2005 electrical problems The car is having a lot strange electrical behavior,it started with the rear door not closing simultaneously with the others than I had problems a few times to ...

how to reset computer on 2007 Chevrolet up-lander after battery change will not start ,starting disable is displayed I am going to take a wild guess and say that the security light was on steady ...

My Service abs system light stays on. How can this problem be fixed? Hi there. There are many reasons why the abs light is on, but usually the problem is one of the wheel speed sensors ( there is one ...

I have a 2008 Chevy Uplander. The Traction control system warning light is coming on very occasionally. It comes on for a few seconds and then goes away. This has happened about 3 times in the past 4 ...

I have a 2008 Chevy Uplander says Bank 4 misfire I don't understand could be bad spark plug or bad injector would be my guess misfire can be from either or both normally it is the injector problem but