door panel and some harness clips. I disconnected the harness at the main body( there is a plug connection) and pulled the harness back thru the door. This gave me the room I needed to make the repair
...locks are slow power windows are slow rolling up and down, and my power locks are slow to Pull the rubber boots off the harness between the door and the body. Im sure yoiu have broken wires in
...harness between door and side wall. If not you might have to replace window regulator/motor. I had the same problem with my wifes car 2007. dr window will not work and power door lock will not unlock ...
Question about Chevrolet Equinox
...if I could get it cheaper somewhere else. The harness at the drivers door is a common problem on the Equinox, you maybe able to fix the wires but it may be less expensive just to replace the
Question about Chevrolet Equinox
...door lock/unlock switch 1. Check harness between BCM and main power window and door lock/unlock switch for open or short. 2. Check harness between main power window and door lock/unlock switch and ...
Question about GMC Cars & Trucks
door vehicles) • PWR WDO CB 25A (IP wiring harness junction block) (System power for RF and RR windows 4-door vehicles) Door Lock System Components The power door lock system consists of the following
Question about Chevrolet Equinox
...Harness wires thru driver door boot are all okay and not broken. Did repair black harness wire 1 year ago, repair is fine. All was working fine until driver window was rolled down and then 2 power ...
Question about Chevrolet Equinox
...door. The wire harness on the passenger side had broken wires. Purple wire was for the lock and thicker blue and darker grey was power for the windows. I used butt connectors to repair and it worked ...
...door trim panel. Engage power mirror wire connector, if equipped. Connect speaker harness wire connector. Engage inside handle linkage rod to inside handle. Align trim panel retainer steps with inner ...
...harness that goes inside the drivers door had a broken wire, hence no power would go to the door locks or the power windows. Check the area where the harness flexes when the door opens and
714 questions posted
Usually answered in minutes!
1,876 Questions
446 Questions
159 Questions
127 Questions
73 Questions