...Module or RCM]. A bad RCM is not common. Check for damage to the seat belt wiring under the driver's seat. Best to remove the seat and lift up the carpeting to do this. If no physical damage or water ...
...Module (RCM) detects a system fault, it will flash a coded sequence which is called a Lamp Fault Code (LFC) on the air bag warning indicator located in the Instrument Cluster (IC) module. The code is ...
Question about Ford Cars & Trucks
...Module (RCM) and Inspection and Repair After a Supplemental Restraint System (SRS) Deployment in this section. B1317 Continuous Lamp Battery Voltage High REFER to Section 414-00 . B1318 Continuous ...
...module (RCM) to complete the testing of the SRS. If the air bag indicator is inoperative and an SRS fault exists, a chime will sound in a pattern of five sets of five beeps. If this occurs, the air ...
module (RCM) checks all of the front air bag circuits for faults. If the RCM detects one of the following faults on any of the front air bag circuits, it will store diagnostic trouble code (DTC) B2293
...module (RCM). The driver safety belt switch is hardwired to the RCM. The RCM communicates with the instrument cluster over a hardwire connection. If at any time during the first 6 seconds after the ...
Question about Ford Crown Victoria
...Module (RCM / located behind right side of the instrument panel) monitors the resistance of the driver side air bag circuit loop and the air bag module igniter at RCM, if the resistance is greater ...
...module (RCM) checks for passenger air bag module circuit shorts to battery or ignition by monitoring the voltage of circuits 607 (LB/OG) and 616 (PK/BK) at C310b, pins 6 and 7. If the RCM detects a ...
...remove excess slack from the safety belt webbing. The pretensioners are activated by the restraints control module (RCM) when the module detects a crash event force exceeding a programmed
...module circuit fault detected. - a microcontroller RAM/ROM/EEPROM fault. Before doing any of the above, disconnect the vehicles battery and Remove the main connection off of the ECS and clean with ...
145 questions posted
Usually answered in minutes!
454 Questions
486 Questions
323 Questions
297 Questions
294 Questions