2008 Nissan Altima Hybrid "remove accelerator pedal" Questions

...can i fix acceleration problem in 08 altima car? service engine light on. mass air flow sensor was removed to see if the problem was here but the car still does not accelerate properly. in park and ...

how can i fix a acceleratioproblem in a 08 nissan altima car check engine light is on. removed mass air flow sensor and check the car the problem remains. car still does not accelerate properly. in ...

...accelerator pedal and you should see a cable, attached to a black gear that turns a white gear. Sometimes the white gear becomes loose and falls out. Nissan Technical Service Bulletin on this. If you ...

to a spot that was near or on the transmission it was located beneath a small square cover which he removed with a 10mm or 13mm. I think just a few bolts like the space was smaller than open hand size

...accelerator pedal as steady as possible. 4. Let engine idle for 10 seconds. 5. If the 1st trip DTC is detected, go to EC-162, "Diagnostic Procedure" . If the 1st trip DTC is not detected, go to next ...

...Disconnect the accelerator pedal position (APP) sensor electrical connector. Reposition the carpet to access the lower nut. Remove the accelerator pedal nuts. Remove the accelerator pedal

remove foot from brake pedal to accelerator pedal Step 4 apply presure to accelerator pedal untill desired speed has been acheived Note these steps will not work for manual transmission see section 37

...remove the steering column if you have not already. Lift the accelerator pedal and slide the heater core past it. Depress the brake pedal and remove the heater core from the heater/air conditioning ...

...ACCELERATOR PEDAL IT HAS BOLTS HOLDING IT IN PLACE.JUST UNPLUG ACCELERATOR CONNECTOR AND REMOVE THE BOLTS THEN SENSOR. I was wondering how do I put my accelerator sensor on a 2004 Pontiac Grand Prix ...

...remove the pedal and sensor assembly. Installation is the reverse of removal. Fig. APP sensor mounting TestingInstall a 3 amp fused jumper wire between the 5-volt reference terminal of the APP sensor ...