2008 Jeep Wrangler "put back sets down" Questions

...put back on. make sure you write down and mark any sensor wires and cables, so you can put them back on properly. If you are really unsure of yourself, get a chiltons or haynes manual or have a shop ...

...put in. specs check ok on engine. jeep won't go past 57 mph, rpms stay at 3, if you back down rpms go down, but won't go past 3 or 57/60 mph. using twice as much gas now. could this be the throttle ...

...back on same thing. Slowly checked each setting, they all work but continues to blow cold air. So i left it on low and put the car in drive and proceeded to work..about half way down my driveway it ...

...Put the small engine up against it and you have about as much grade or hill climbing ability as a ride on mower! There are three practical ways of getting back some performance. The first is simply ...

...back. Anyone ever bolt a 3rd set in? Bolting it in a third row seat? that'd be fairly easy...just need something solid to anchor it to (like a thick piece of metal) on the underside to put the bolt ...

...put on and the front end allinged and the track bar seems tight. I have a Rubicon with 265-75-16 tirs and there is a winch on front.I bought this used about 3 weeks ago. I'm driving down the road ...

down the rust that caused the door pin the swell up and get stuck in the hinge sockets in the first place. Finally, I greased up the door pin with heavy grease to prevent further rust from developing.

...back over the gear. You will see the slot the "C" retainer clip will fit over. Press the clip "partially" over the slot, so that when you press forward, once the handle is on the gear, with your tool ...

back into the sport. I miss it. It's easy, I have one myself. To engage your 4WD, put your transmission in nutral (take it out of gear), than shift your 4WD lever to 4H. Then you can chift back to 1st

...back ( anticlockwise ) about 3/4 of an inch and put a second mark on the timing cover That second mark will be close to 10 degrees and will be within the parameters for the ECM to adjust the timing ...