2007 Jeep Commander Rocky Mountain "replace liftgate" Questions

break kight burned out How do I remove the tail light to replace the bulb for a 2006 jeep Comander Open the liftgat and you should see the screws on the side of the lamp. Unscrew then and pull the ...

replace it. I can't figure out how to take off the red light covering. I even called a Jeep service station and he was clueless. HELP [email protected] Open the liftgate, then look along the inside

...replace it? Is there a button somewhere or manual lever? There is NO key hole. The liftgate consists of the following components: liftgate door lock actuator liftgate lock cylinder (if equipped) ...

where is the power tailgate lock actuator fuse on a 2008 Cadillac SRX Power Liftgate System Components • Liftgate motor assembly • Liftgate latch • Liftgate module (LGM) • Liftgate side upper sensor -

...lift motor would run but nothing would happen but I could open it from out side with the handle I replaced the lift assembly and now it dosent work at all I have power going into the module on 2

interior panel from tailgate? Remove the liftgate pull handle. Refer to Liftgate Inside Pull Handle Replacement . DO NOT attempt to remove the liftgate trim panel if there is a failure of the electric

what causes message rear door open on the DIC? The liftgate will not open or close. 2011 Cadillac SRX Door ajar switch possibly . The lift gate not working is a different matter . Could be any number ...

...replace 3rd brake lite chrysler pacific 1.Open liftgate before disconnecting battery. 2.Open hood, disconnect and isolate the battery negative cable. 3.Open liftgate. 4.Disconnect the power liftgate ...

...liftgate to replace the latch. You should be able to pull the liftgate trim off most of the way with the gate closed and try to manually actuate the latch to open the gate. You may have to go so far ...

...replace the Liftgate Release switch. Liftgate Release Malfunction Ignition OFF, disconnect the harness connector at the Liftgate Latch Assembly. Ignition OFF, test for less than 1.0 ohm of resistance ...