...back seat cushion. You have to remove the seat to get to the hydraulic pump. to remove the seat you use a large screwdriver between your floor and the seat bottom at the front about a foot from each ...
Question about Chrysler Sebring
...seat does not back and forth front driver seat does move up and down, but, will not travel to dash and extend back for tall people this seat likely has two different motors to operate these functions ...
back seat.lift up front of bottom cusion,pull forward,remove.lift up on seat back,like it's hanging on hooks.remove.locate fill screw or rubber plug on top of resevior.w/ top down fluid should be 1/2'
motor and if so where is the motor located for the convertable top remove the back seat, its between the seat back and the trunk area. There is a hydrolic cylinder there as well, check the fluid level
Question about Chrysler Sebring
...seat back and reach in with a magnet or grabbers. there is structure so you will not be able to crawl back there like some sedans. the seat back attaches with hooks and tabs. you have to pull out on ...
...seat belt on my 1998 was pulled to far out and now wont retract back.What can I do/thanks You'll have to remove the trim on the side of the car in order to access the seat belt tensioner. You can ...
Question about Chrysler Sebring
...seat back and inner quarter trim panels. Pull up sharply on the seat cushion at the front about midway between the middle of the seat and the outside edges. The seat back is held in by nuts. The ...
...seat front to back motor stuck forward Switch sometimes stuck forward and would run till battery dead. Now the motor wont go, stuck forward, suspect motor burned up since battery fine. Is it same ...
back up. I have to help it manually. Some said i need to pull my rear seats to check for a hydrulic leak, and add fluid. push hard in at the base of the seat then lift up. Why not get to the pump from
528 questions posted
Usually answered in minutes!
1,173 Questions
965 Questions
801 Questions
581 Questions
462 Questions