Juki DDL-8700 "thread keeps getting pulled needle" Questions

...thread keeps coming out the needle after threading the needle pull about 6" of thread out the back under the press foot that way the thread is jammed under the foot and is held in place for the next ...

...the handwheel untill the needle picks up the bottom thread and by pulling the top thread you shold be able to pull the botoom thread through the needle plate. Practise makes perfect. Regards ...

...keeps coming unthreaded. Then when it will stay it gets all clogged up in bobbin PLEASE HELP its driving me mad, i have tryed everything and i can't seem to get any further, thank you for your time i ...

...keeps breaking and the thread wont stay threaded. the needle is not going straight up and down but it goes down and gets stuck almost usually a 3-5 inch thread tail is helpful to keep the thread from ...

...thread keeps getting tangled because of this? any help? am i doing something wrong ith the tread? x thnks sam x Not familiar with your machine, but an important suggestion for all sewing machines: ...

...thread keeps getting all bunched up plus I lost my instruction manual can I gat a new one About the needle problem, Brother's FAQ gives the following response: Make sure the needle is correctly ...

...thread keeps catching and bunching up under the needle plate. The top thread will break and tear through the fabric. I have to take the needle plate off to get all the thread out. Please help! Raise ...

...thread that goes through the needle. As soon as I start it breaks. It seems to be getting tangled in the bottom and I have to keep pulling it out and cutting it where it gets tangled. What do I do? I ...

...thread keeps popping out of the needle and getting wrapped around the thingy that makes it go up and down, any ideas why? I hav change the threadput in a new needle--normally flat side goes to the ...

...thread is somehow pulled out of the needle? Have threaded needle and out bobbin in checked tension etc. when plain straight stitching the thread pulls out of needle. How do I correct this please? If ...