Brother CS6000i Computerized Sewing Machine "put lower threading case" Questions

...Put fabric scrap under presser presser foot and LOWER it now. Make sure, too, that the needle is correct size for fabric you're sewing. 9. Do a test. You may need to set tension at 4, stitch ...

...lower thread (bobbin thread) while stitching, as it seems to be very loose. Hello On your bobbin case where you run the thread through the case you will see a plate with a screw on top of the bobbin ...

...lower the foot and tug to see if a resistance is in place. If there's not then check the tension disc for the flow. 1. Bobbin case- Side and Front. Put bobbin in dispensing counter clockwise. 2. Feed ...

...lower the tension to stop the jamming of the bobbin thread. c. Clean the bobbin area. Check the bobbin tension and adjust as you need to. d. Put a drop of oil on the race. (Thing the bobbin case sits ...

...put back), identify the problem and try to remove the thread. Inspect the inside of the machine and the lower bobbin case for thread that may be tangled . Take it easy and you will fix it ; most of ...

...lower left notch and make sure the thread stays behind the spring slot and leave about 4"tail...put bobbin in its place lining up the white dots close the case and turn the wheel to drive down needle ...

...lower, upper gets caught and crosses). Tension and length set at 3. Straight stitch set but when jam (tangle) occured I was using decorative stitch 6 on light fabric with size 11 needle.I have ...

...machine's pressure foot up. Then pull the threads by hand to the back of the machine. If the upper thread does not catch the lower thread then the bobbin is not correctly threaded in the bobbin

lower thread is just a mess and it seems the bobbin is unravelling. Have I thread it wrong? did you put the bobbin thread in the tensioner? that would be the cut in the side of the bobbin case to pull